Use Wind Power and These 5 Tips to Save Energy and Money

by Tony Tedbos on 2010/03/10

With the economy the way it is today with many unemployed, many who may be facing unemployment, and trying to keep up with rising costs, it becomes even more important to cut costs wherever we can. Therefore, here are five tips you can use with or without the use of wind power to help cut costs year round.

1. Furnaces and a/c units that do not get serviced yearly can lose efficiency costing you more money in your utility bill. Having them serviced on a yearly basis will keep them in top running condition, prolonging their life which will save you from a costly replacement bill. The climate you live in does not matter because regular servicing will save money and energy no matter where you live. Along with regular servicing, get in the habit of changing the filter once a month because a dirty filter will cut down on efficiency and can cause premature failure of the units.

2. Consider replacing your manual thermostat with a programmable one. There are many who try to save energy and money by turning the thermostat way down in the winter when they leave the house, or way up in the summer, and this fine as long you do not go to extremes. Turning the temperature way up or way down will cause the furnace or a/c to run excessively to bring the temperature back to a comfortable level. Changing the thermostat manually works good if you don't forget to do it, which is why I suggested replacing the old manual one with a programmable one, set it and forget it until the seasons change, this way you gain maximum benefits and savings.

3. The following can be done in a matter of hours with a few inexpensive things you will need to pick up at your local hardware store. You will need a few tubes of caulking (how many will depend on how many exterior doors and windows you have) and some foam gaskets that are used to seal outdoor outlets and switches. (again how many will depend on how many outlets and switches you have located on exterior walls) Once you have these items start by caulking around all exterior doors and windows to seal air leaks then, remove all the covers on switches and outlets that are located on exterior walls, place a gasket over the switch or outlet, replace the cover, and trim the excess off with a utility knife. The more air leaks you seal the more you will save.

4. Fewer and fewer homes are built today with real wood burning fireplaces but, if you do have one and use it regularly in the winter, you should also have it and the chimney cleaned once a year. Burning wood can save a lot of money on heat bills in the winter but a heavy build up of creosote can cause chimney fires. If the chimney does not have a screen and cap on it, you should have one put on. Birds will sit on top of the chimney for the warmth, and then be overcome by the fumes, causing them die and fall into the chimney. This can cause smoke to back up into the house.

5. This one will save you the most money. A windmill to produce your own power can cut your utility bill by at least 60%. That right 60% or more and with today's technology they can be constructed to fit on the roof and built for three hundred dollars or less. All that is required is a minimum of eleven mph winds, which can be found in just about any state you live in. Plus the windier it is, the more power the windmill will produce, the more you will save.

With the cost of living rising every day and threat of losing your job, it is even more important to use wind power to reduce your utility bill. Click here to discover affordable ways to use renewable energy sources.


Related Reading:

41x3kWCO1jL. SL75  Use Wind Power and These 5 Tips to Save Energy and Money
51U2gRohGYL. SL75  Use Wind Power and These 5 Tips to Save Energy and Money
51eh2pcRjeL. SL75  Use Wind Power and These 5 Tips to Save Energy and Money
41dhWL4beuL. SL75  Use Wind Power and These 5 Tips to Save Energy and Money
51ARfmS fIL. SL75  Use Wind Power and These 5 Tips to Save Energy and Money

Leave a Comment

Previous post:

Next post: